* Urban / interurban / total (depending on rear-axle ratio and unladen weight of vehicle)
** The fuel consumption figures were ascertained (under laboratory conditions) in accordance with Article 2 of Directive 80/1268/EEC, version 1999/100/EC. These figures are valid for vehicles to be registered as passenger cars, with a gross weight up to 3500 kg, excluding camper vans.
*** According to DIN 70020: incl. driver (68 kg), luggage (7 kg), all service fluids and tank 90% full
¹ |
Name |
Qty |
1
|
Reinforcing of ambulance’s body for fastening devices and attached implement; noise and thermo insulation
|
1 |
2
|
Furnish of lateral panels and ceiling with aluminum sheet with a smooth surface. It is steady against the influence of medical products and disinfectant solution and does not absorb smells. |
1 |
3
|
Waterproof floor covering is antistatic, not sliding and with joint encapsulation. It is steady against the influence of disinfectant solution |
1 |
4 |
Glazed back doors |
2 |
5 |
Partition between driver’s cabin and patient’s compartment has a movable window |
1 |
6 |
Right side door has a movable window |
1 |
7 |
Metallic handles near the door (rear door and side door) |
2 |
8 |
2/3 matting of glasses |
1 |
|
12 V Electrical system |
|
9 |
Laying of conductor cables under the coating of the body |
1 |
10 |
Lamps for daylight illumination with switches on side and back doors |
6 |
11 |
Lamps for illumination of the stairs and rear interior of medical compartment |
2 |
12 |
Dotted lamp in the area of patient’s head |
1 |
13 |
Roof-mounted flashing light panel |
1 |
14 |
Signal-loud speaking device |
1 |
15 |
Flashing beacons |
2 |
16 |
12V/220V tension converter with function of automatic charger of accumulator |
1 |
17 |
12V sockets for medical equipment connection |
3 |
|
220 V Electrical system |
|
18 |
Laying of conductor cables under the coating of the body |
1 |
19 |
220V inside sockets |
3 |
20 |
220V outside socket, safety board and connecting cable of 15m |
1 |
|
System of heating and ventilation |
|
21 |
Air-conditioning |
1 |
22 |
Water-dependent heating |
1 |
23 |
Ceiling ventilation with combined input and output vents |
1 |
|
Furniture of medical compartment |
|
24 |
Medical furniture is made of nonpolluting material (hypo-allergenic). It doesn’t crack with the influence of moisture (unlike wooden panel). It is shockproof and is easily cleaned with disinfectant solutions. |
1 |
25 |
Storage space over the driver’s cab with a closable lid |
1 |
26 |
Rotary seat is located in front of the stretcher |
1 |
27 |
Seat for doctor and nurses is located on the right board |
1 |
28 |
Medical storage with shelves is located on the left board of medical compartment |
1 |
29 |
Vertical bar for fastening medical equipment |
1 |
30 |
Roof-mounted fluid bottle holder |
1 |
|
Oxygen system |
|
31 |
Laying of oxygen hoses under the coating of the body |
|
32 |
10 l oxygen cylinder |
2 |
33 |
Holder of oxygen cylinder |
2 |
34 |
Protective cover for oxygen cylinder |
2 |
35 |
Metallic support for an oxygen cylinder |
2 |
36 |
Reducer for oxygen cylinder |
1 |
37 |
Oxygen socket |
2 |
|
Stretchers |
|
38 |
Primary stretcher Ferno model 25, “FERNO” USA |
1 |
